You are trying to set your feedrate feed rate in Mastercam and the following prompts prompt pops-up:
The reason why you are getting this message might be because you are defining a feedrate feed rate greater than the maximum one allowed by your Mastercam machine definition.
There are 2 ways to solve this issue, permanently, or only for a single session.
Step-by-step guide
How to change Feed Rate Permanently (Including subsequent sessions):
- Go to Settings / Control Machine Manager...
the Machine Tab and select Machine Definition - Click on the Green Check Mark
3. Click on the Edit
...
General Machine Definition Parameters icon
4. Set your
...
feed rate limits as desired:
How to change Feed Rate for a single session:
- After selecting your Machine (Robot Brand), in the Toolpath Manager, Click on Files
2. Click on Edit
3. Click on the Edit General Machine Definition Parameters icon
4. Set your feed rate limits as desired:
Info |
---|
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Page Properties | |||
---|---|---|---|
| |||
|