Page Comparison

You are trying to set your feedrate feed rate in Mastercam and the following prompt pops-up:

...

There are 2 ways to solve this issue, permanently, or only for a single session. 

Step-by-step guide

How to change Feed Rate Permanently (Including subsequent sessions):

1. Go to the Machine Tab  / Machine Definition... and select Machine Definition
   
   
   
   
2. Click on the green check mark Green Check Mark

      3. Click on the Edit general machine definition parameters General Machine Definition Parameters icon

      4. Set your feed rate limits as desired:

         

How to change Feed Rate for a single session:

1. After selecting your Machine (Robot Brand), in the Toolpath Manager, Click on Files

...

      3. Click on the Edit general machine definition parameters General Machine Definition Parameters icon

      4. Set your feed rate limits as desired:

         

...