Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

This page introduces how to properly use the preliminary support for 3P3R robot. Once the complete support is ready, this page will not be valid anymore.

Step-by-step guide

  1. Set Robx file:
    1. The robot architecture type in Robx file must be set to "DECOUPLED_3P3R".
    2. Set DH chart. The first three links are set basing on wrist centre position.
    3. Add the joints holding part to <tempVariables>.  For example, if second joint of robot holds part, it would be set as: 
  2. Set Simulation XML file.
    1. Set the joint holding part to part chain.






 

It does support G-code generation, simulation and optimization.

It can support external axes control too, so robot cell could contain external axis.

No Base and Elbow configuration existing for this type of robot. Thus, it does not change anything by changing the base and elbow configuration setting. (These two setting in GUI will be disabled in future for 3P3R robot. )

Only prismatic joints can hold part. The robot with more than one joint holding part can be supported theoretical but is not tested yet.

 

Filter by label

There are no items with the selected labels at this time.

  • No labels