/
ERROR- Toolchanges not supported by workcell
ERROR- Toolchanges not supported by workcell
Problem
If a Mastercam program has multiple tool changes this error will pop up when trying to post.
Solution
In order to prevent this error from popping up you must enable Use tool name as tool call macro within the Tool and Configuration tab found within Global settings
If you are using a RTCP cell and are encountering this error, you may also want to refer to How to set multiple frames for a RTCP cell in V6
Related articles
, multiple selections available,
Related content
Multi-Robots - Cell Editor - Configuration
Multi-Robots - Cell Editor - Configuration
More like this
Set up a multi-robot configuration in the cell editor
Set up a multi-robot configuration in the cell editor
More like this
10.0 Simultaneous Multi-Robot Walkthrough
10.0 Simultaneous Multi-Robot Walkthrough
More like this
Multi-Robots - Licensing
Multi-Robots - Licensing
More like this
How to install Robotmaster V6 , Mastercam, & Other Modules
How to install Robotmaster V6 , Mastercam, & Other Modules
More like this
Robotmaster Getting Started Guide
Robotmaster Getting Started Guide
More like this