Additive Module
- Rebecca Falus (Deactivated)
- Andrew Haggerty
- 1 Viewport Toolbar
- 2 Setup
- 2.1 Simulate deposition
- 2.2 Material width
- 2.3 Material thickness
- 2.4 Material shape
- 2.5 Material color
Viewport Toolbar
At the top of the Device side viewport is the upper menu, which contains a button for material deposition. Here, you can choose to Display material or Clear material.
Display material - Toggles whether added material is displayed on the part.
Clear material - Removes previously added material from the part.
Setup
Simulate deposition
To enable these overrides the depositing simulation must be enabled. This is done by switching on the Simulate deposition button to on.
Material width
The width of the simulated material can be changed to any numerical value up to 100mm using the text box.
Material thickness
The thickness can also be changed to any numerical value up to 100mm using the text box.
Material shape
The simulated material deposition can either use a Circle or Square tip.
Material color
The color of the simulated material can be changed using ARGB sliders.