Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

This page introduces how to apply 3P3R robot. 

Step-by-step guide

  1. Download the build supporting 3P3R robot from robotmaster website. The build number is: Robotmaster_V6.1.4058.
  2. Set Robx file:
    1. The robot architecture type in Robx file must be set to "DECOUPLED_3P3R".
    2. Set DH chart. The first three links are set basing on wrist centre position.
    3. Add the joints holding part to <tempVariables>.  For example, if second joint of robot holds part, it would be set as: 
  3. Set Simulation XML file.
    1. Set the joint holding part to part chain.

Two 3P3R robots have been set up and are attached in here:

RM_CELL_E1_E2_E3_Wrist_TOOL-PART.zip

KMC3P3R.zip

 

It does support G-code generation, simulation and optimization.

It can support external axes control too, so robot cell could contain external axis.

No Base and Elbow configuration existing for this type of robot. Thus, it does not change anything by changing the base and elbow configuration setting. (These two setting in GUI will be disabled in future for 3P3R robot. )

No work space zone displayed for 3P3R robot.

Only prismatic joints can hold part. The robot with more than one joint holding part can be supported theoretical but is not tested yet.

No RTCP case support for 3P3R robot yet.

 

Filter by label

There are no items with the selected labels at this time.

  • No labels