This page will show you how to add a Robotmaster toolbar in the Mastercam workspace.
Step-by-step guide
- Open Mastercam
- Go to Settings Right click on the Ribbon area / Customize (press right click)...
...
Info | ||
---|---|---|
You have just created the Robotmaster toolbar. It will be floating in the interface. You can snap it with the other toolbars by draging it in the interface. Mastercam X6 layout differs a little :
|
3. Under Customize the Ribbon, click on the "New Tap" which will create a new tap and a new group automatically. You can then rename them to Robotmaster and V6.7, respectively.
4. From the left side, select the All Commands / look for Robotmaster V6 icons / add them all under V6.7 that you just created and then press OK.
Warning |
---|
If Robomaster doesn't appear in the category list, it means Robotmaster adapters for your mastercam version have not been properly installed. See this how to article : How to install/repair mastercam adapters ? |
...
Tutorial video :
...
Multimedia | |||
---|---|---|---|
|
...
|
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Page Properties | |||
---|---|---|---|
| |||
|