...
You can control what paths are selected using the slider, which filters out features based on relative size. Those not filtered out will be highlighted in the viewport. Once you are happy with selected paths you can click OK, or Add all to path list to add the highlighted paths to your path list.
Alternatively, you can click OK and it will bring up a dialogue box that says “You have not added any cut path to the path list. Do you want to add all visible cut paths now?” Giving the options Add, No, or Cancel.
...
Add selected to path list
If you have decided to select paths by clicking them in the viewpor, holding Ctrl to select multiple. Once selected the Add all to path list button will instead say Add selected to path list. It will do the same thing, but only apply to the selected paths, which will have a different colored highlight to the others.
Refresh from selected surfaces
By selecting a surface, then clicking the Refresh from selected surfaces button, you will restrict the generated cuts to only applying for that feature.
Message prompt
Once a selection is made Alternatively, you can click OK and it will bring up a dialogue box that says “You have not added any cut path selected some cut paths without adding them to the path list. Do you want to add all visible cut paths them now?” Giving the options Add, No, or Cancel.
...
...
Refresh from selected surfaces
By selecting a surface, or several tangent surfaces, and then clicking Refresh from selected surfaces button, you will restrict paths generation to contours that consist of the selected surface(-s) edges.
Advanced settings
...
Set path direction
The Set path direction setting is a dropdown with the options being either For left side compensation, or For right side compensation, which defines the side of generated path(-s) where kerf compensation will be applied.
Swarf mode
The Swarf mode keeps the side of the tool in contact with the selected surface(-s) using one of the two methods listed in the dropdown menu: Automatic, or Short distanced Shortest distance. For Automatic the , tool axis control vector alignment is based on the side wall geometry. For Short Shortest distance, it is based on the shortest distance between the upper and lower edged edges of the selected surface(-s).
Max direction error
This setting allows you to type in your preferred tolerated Max direction error between 0.01 and 45.
...
Path names are generated and ordered with the format Hole #_ Cut #_. The cuts Each path constitutes a cut, a hole may or may not consist of several cuts (e.g. beveled holes).
Paths are automatically ordered and labeled based on the plasma cutting technology, so it is highly recommended for them to be left as they are generated. In case the paths order is changed from automatically generated, Hypertherm cutting technology is no longer applicable to the program.