This page will show you how to add a Robotmaster toolbar in the Mastercam workspace.
Step-by-step guide
- Open Mastercam
- Go to Settings Right click on the Ribbon area / Customize (press right click)...
...
3. Under Customize the Ribbon, click on the "New Tap" which will create a new tap and a new group automatically. You can then rename them to Robotmaster and V6.7, respectively.
4. From the left side, select the All Commands / look for Robotmaster V6 icons / add them all under V6.7 that you just created and then press OK.
| Warning |
|---|
If Robomaster doesn't appear in the category list, it means Robotmaster adapters for your mastercam version have not been properly installed. See this how to article : How to install/repair mastercam adapters ? |
Tutorial video :
| Multimedia | ||||
|---|---|---|---|---|
|
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | |||
|---|---|---|---|
| |||
|