This page will show you how to add a Robotmaster toolbar in the Mastercam workspace.
...
- Open Mastercam
- Go to Settings / Customize...
- Under Category select Robotmaster_V6.X
- Do a right-click in the toolbar section and select New Toolbar and give it a name:
Mastercam 2017 2017,2018
Mastercam X8-X9
- Make sure that the new toolbar is selcted
- Select the Robotmaster icons and click on Add:
- Click on OK
| Info | ||
|---|---|---|
You have just created the Robotmaster toolbar. It will be floating in the interface. You can snap it with the other toolbars by draging it in the interface. Mastercam X6 layout differs a little :
|
| Warning |
|---|
If Robomaster doesn't appear in the category list, it means Robotmaster adapters for your mastercam version have not been properly installed. See this how to article : How to install/repair mastercam adapters ? |
Tutorial video :
| Multimedia | ||||||
|---|---|---|---|---|---|---|
|
...
| Page Properties | |||
|---|---|---|---|
| |||
|