Page Comparison

Additional angle

Only available for linear entry / exit types (Perpendicular or Tangent). This adjusts the entry or exit path by a specified angle.

...

Arc radius

For arc style entry or exit paths, this is the radius of the arc. Use this to control the size of the entry or exit.

...

Arc sweep angle

For arc entry or exit paths, this is the distance to sweep the arc, from the intersecting point on the toolpath.

...

Line length

Used with linear entry or exit, defines length in mm of entry or exit motion. Negative values are not permitted.

...

Extend / shorten path

A positive value will extend the base toolpath by adding a line tangent to the path, at the intersection of the entry / exit. The effect would be to move the entry or exit past the intersection point, creating an overlap.

...

A negative value will move the entry / exit away from the intersection point, leaving undertravel or a gap in the base toolpath.

...

Note that on curved toolpaths, the extension follows a tangent line, it does not follow contour of the toolpath.

...

Normalize direction

...