...
Entry and exit motions can be placed on the right or left side of a path. You can use this setting to correct situations where entry / or exit motions are placed on the wrong side of a path.
...
Height / ramp
The height relative to the entry / exit point where the entry / exit point begins and endsCreate an incline on an entry or exit motion. Ramp height is the offset distance from the original start point of the entry or exit, along the approach vector.
...
Ramp height can also be used with Arc entry or exit paths.
This option is not
...
recommended for plasma cutting.
Additional angle
Only available for linear entry / exit types (Perpendicular or Tangent). This adjusts the entry / or exit path by a specified angle.
...
Arc radius
For arc style lead-ins or lead-outsArc entry or exit paths, this is the radius of the arc. Use this to control the size of the entry or exit.
...
Arc sweep angle
For arc style entry and or exit paths, this is used to control the arc length.image of 60, 90, 180 the angular distance the arc sweeps from the connecting point on the tool path.
...
Line length
Used with linear entry or exit, defines length in mm of entry or exit motion. Negative values are not permitted.
...
When cleared, the vector of approach will be parallel to the cut path vector.
This option is available for plasma cutting only.
Fanning distance
When the Normalize direction option is enabled, Fanning distance controls the distance of the transition from the initial pierce vector to the cut path vector.
(image)
Set this to Automatic to transition gradually along the entire length of the entry or exit.
This option is available for plasma cutting only.
Use the Apply button as you edit leads to see changes.
...