...
These properties apply to both entry and exit.
Enter / exit at midpoint
In On a closed pathspath, this moves the entry / exit point to the midpoint of the path’s first curvesegment.
Closed loop overlap
In On a closed pathspath, this extends the start and end of the path to cause an overlap. Only positive values are permitted.
...
The height relative to the entry / exit point where the entry / exit point begins and ends.
This option is not available with plasma cutting.
Additional angle
Only available for linear entry / exit types (Perpendicular or Tangent). This adjusts the entry / exit path by a specified angle.
...
Arc sweep angle
For arc style leadsentry and exit, this is used to control the arc length.
...
When enabled, the vector of approach will be perpendicular to the healed surface geometry, at the start of the entry. This will ensure that the pierce occurs with the torch perpendicular to the workpiece. After piercing, the vector gradually transitions to the cut path vector, as defined with Fanning distance.
...
When cleared, the vector of approach will be parallel to the cut path vector.
...
This option is available for plasma cutting only.
...
Use the Apply button as you edit leads to see changes.
...