| Table of Contents | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Kerf correction
Kerf correction is an option that allows the user to increase or decrease the radius/diameter of a hole by increasing or decreasing the offset of the plasma beam to the part’s edge. A positive Kerf correction will make a hole smaller. A negative Kerf correction will make a hole bigger, A Kerf correction of 0 will disable Kerf correction, resulting in a Kerf based on Hypertherm’s XPR cutchartscut charts.
...
...
Error message strings
...
Chaining tool improvements for Marking
The chaining menu of “Curve Path” Curve Path has been improved to allow better wireframe selection for Marking or 2D cutting.
Window selection filter
This dropdown menu sets the behavior of a “window selection” window selection (holding the mouse left button pressed, moving the cursor, and releasing the mouse button).
Closed chains only
This option will only select the closed loop wireframe.
Open chains only
This option will only select the open loop wireframe.
Mixed
This option will select both the open and closed loops.
